[GNC-dev] Co-Owner

[Ralf Zerres]

Am Freitag, dem 10.06.2022 um 10:41 -0700 schrieb John Ralls:

> 
> I did a test-build of your wip-coowner branch and had no trouble with
> unittest-support.scm, so perhaps you have a build environment
> problem.
Digging in a bit deeper, i did found some typo. I had faulty references
to *customer* where it should be *coowner*. The missing terms functions
was added, sources changed and commited to the branch. I did push all
changes and some new updates to the branch. 

Since it is WIP i used --force-with-lease. Just because i don't expect
code changes from third party yet (I know about the trouble, if I would
do this in published trees :( ).

> If you're trying to develop on Win32, I suggest that you use WSL.
> Developing directly in the MSYS2 environment is an exercise in
> frustration.
> 
Thank's again. Appreciate taken the time.
But no, i'm primary developing on linux. And the toolchain seems to
work quite well (using Arch Linux).


> I didn't get a clean build, though: Linking libgncengine.so failed
> because
> 
> Undefined symbols for architecture x86_64:
>   "_gncCoOwnerGetTerms", referenced from:
>       _gncCoOwnerRegister.params in gncCoOwner.c.o
> ld: symbol(s) not found for architecture x86_64
> 
> Examining the source shows there's no definition for
> gncCoOwnerGetTerms.
> 

With all that changes, the branch now compiles without any glitches.
This status has me first of all already quite satisfactory!

> Regards,
> John Ralls
> 
regards
Ralf