Build Problem 2.2 Ubuntu Fiesty

[Dan Schmidt]

Gar!  No, I didn't, thank you very much for the tip!!

I have another problem now - on install I get an error message saying it 
wishes to replace /usr/bin/strip with is in use by binutils.  I don't 
want to screw up my system by forcing install. 

Of course, I am using checkinstall instead of make.   I didn't have any 
problems on Edgy.  Maybe it's a checkinstall problem, I don't know.  
Maybe I should try make?

Any help greatly appreciated,
-Dan

Derek Atkins wrote:
> Quoting Dan Schmidt <helpdeskdan at gmail.com>:
>
>>   Another user had the following problem:
>>> config.status: creating po/Makefile.in
>>> config.status: executing depfiles commands
>>> config.status: executing intltool commands
>>> config.status: executing default-1 commands
>>> config.status: executing po/stamp-it commands
>>> make[2]: Leaving directory `/home/ron/Desktop/gnucash-2.2.0/po'
>>> make[2]: Entering directory `/home/ron/Desktop/gnucash-2.2.0/po'
>>> file=`echo ca | sed 's,.*/,,'`.gmo \
>>>          && rm -f $file &&  -o $file ca.po
>>> /bin/sh: -o: not found
>>> make[2]: *** [ca.gmo] Error 127
>>> make[2]: Leaving directory `/home/ron/Desktop/gnucash-2.2.0/po'
>>> make[1]: *** [all-recursive] Error 1
>>> make[1]: Leaving directory `/home/ron/Desktop/gnucash-2.2.0'
>>> make: *** [all] Error 2
>>
>>   The solution was to install gettext, however, I have gettext and 
>> gettext
>>   common installed and I still get this exact error.  Any ideas/help 
>> greatly
>>   appreciated.
>>   Thanks,
>>   -Dan
>
> Did you re-run configure after installing gettext?
>
>> Please remember to CC this list on all your replies.
>> You can do this by using Reply-To-List or Reply-All.
>
> -derek
>