[GNC] 'Total Period' shows 'Total' for one bank account

[G R Hewitt]

Thanks Adrien,
I had a rummage through the lists, maybe I missed it as all I could find
was a similar problem in version 2 some years back.
Never mind, these are personal finances and the registers are correct so
it's no biggie, and it is only that one sub-account. There are other
figures I noted that don't add up here and there
but I put it down to 'that is the way it is'. I don't think I shall waste
any more time on it, but thanks for the suggestion.

On Fri, 2 Feb 2024 at 06:55, Adrien Monteleone <
adrien.monteleone at lusfiber.net> wrote:

> This sounds familiar. Perhaps search the last few months of the list
> archive for 'Total(Period)' and you should find at least one more thread
> on this. It might be a bug. (and may be already filed, so a search on
> Bugzilla would be in order.)
>
> Regards,
> Adrien
>
> On 2/1/24 5:51 AM, G R Hewitt wrote:
> > Hello everyone,
> > MacPro 2010 High Sierra 10.13.6
> > GnuCash 5.5 Build ID: 5.5+(2023-12-16)
> >
> > I only just noticed, but I'm pretty sure it was correct before, that one
> > 'child' bank account is showing the 'Total' instead of the 'Total
> (Period)'.
> > I have:
> >
> >     - Run the check and repair (all of them)
> >     - Disabled and re-enabled the total columns
> >     - Installed GnuCash 5.4 - problem remains
> >     - Checked the settings of the account against an identical account,
> save
> >     the name
> >
> > all to no avail.
> > An example set up is as follows:
> > Total        Total(Period)
> > Bank Savings            10,000         5,000
> >        A/c 1                     3,000          2,000
> >        A/c 2                      7,000         7,000  <---- should be
> 3,000
>
> _______________________________________________
> gnucash-user mailing list
> gnucash-user at gnucash.org
> To update your subscription preferences or to unsubscribe:
> https://lists.gnucash.org/mailman/listinfo/gnucash-user
> -----
> Please remember to CC this list on all your replies.
> You can do this by using Reply-To-List or Reply-All.
>