[GNC] Reconciliation {oops}

[Adrien Monteleone]

Clicking the column doesn't mass change transactions.

I'd say you are either viewing an opposing register in basic mode, or 
you did something else entirely to produce that result.

Figuring that out is likely the best bet.

Otherwise, just do a new reconciliation and mass-select them all. That 
should only take a few clicks.

Regards,
Adrien

On 3/23/26 4:25 PM, Mark at Lorimark wrote:
> So, looking at one of my registers, I see a few hundred transactions up 
> a reconciliation 'Y' is now a 'N'...  I must have accidentality clicked 
> on the column and cleared the reconciliation.
> 
> How can I get the 'Y' reapplied without having to go through all the 
> reconciliation steps all over again?
>