guppi & gnucash builds but doesn't run

[Christian Stimming]

-----BEGIN PGP SIGNED MESSAGE-----

On Friday 12 October 2001 12:51 am, Christian Stimming wrote:
> On Thursday 11 October 2001 08:27 pm, Jon Trowbridge wrote:
> > On Thu, 2001-10-11 at 05:49, Christian Stimming wrote:
> > > I sucessfully built guppi from cvs HEAD, and I built the stable
> > > gnucash-1.6 with guppi HEAD installed. However, when I try to run
> > > gnucash, I get
> > >
> > > chs@ckiste:~ > gnucash
> > > ERROR: In procedure dynamic-link:
> > > ERROR: file not found
> >
> > That is a guile problem.  What version are you using?
>
> Quite good guess. It turns out that the problem was caused by two different
> g-wrap version hangin around and interfering with each other. Now I cleaned
> up a bit, and I eventually got gnucash 1.6 to work -- well, almost. Now I
> get the error message
>
> chs@ckiste:~ > gnucash
> ERROR: In procedure scm-error in expression (scm-error (quote misc-error)
> #f ...):
> ERROR: no such module (www main)

Fortunately our most active gnome developer Dave P. always has some helpful 
advice on IRC... Upon checking src/guile/gnucash.c, I discovered that 
G_WRAP_MODULE_DIR wasn't set correctly (gnucash.c hasn't been rebuild after 
the above g-wrap installation change). After I got this straight, everything 
is now working.

Everything means: Guppi cvs HEAD as of now DOES work with gnucash-1.6 (easily 
recognizable by tons of debug messages). Hooray trow! Keep up the good work!

That's Gnucash 1.6, guile 1.4, guppi HEAD, g-wrap 1.1.10.

Christian
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.5 (GNU/Linux)
Comment: For info see http://www.gnupg.org

iQCVAwUBO8aydGXAi+BfhivFAQGaBgP/WMRo+328sqmhMOYLRgezSjAOOmyTXnk/
/wqlHmZHga0cCcFab/pvlIkxVrmu7KUE279qHow0xORnvFlwlt1gK+UZz9GZfjXd
MAy7B61iKUPfe+6kOc80vBcER4HfJaB5Rx2O5Lbn/nJu9HQskrI8whM5lShi6h7y
w2dlUmXkPLE=
=Q6B0
-----END PGP SIGNATURE-----